Flamingo - Atelier

INSTALLATION GUIDELINES

We advise you to install the wallpaper on a properly prepared surface:

- old support
clean old paint, without cracks, flaking or roughness
- new support
well smooth plaster, prepared with a primer or undercoat of paint

Respect the water/glue dosage indicated by each manufacturer.
For a correct setting of the glue and a better result, avoid laying in a room where the temperature is too hot or too cold (min 8°, max 25°). Laying in high heat can cause the glue to set too quickly and cause the paper to shrink after laying.

Our wallpapers are produced either in digital printing or traditional printing (rotogravure). In both cases, dimensional deformation tolerances are 1.5mm/1000mm.

MORE INFORMATION

(1) Walldecor NFB Semi-Satin Anti Fire

BS1d0 classification carried out in accordance with EN 13501-1:2018

The product is a non-woven wallpaper based on cellulose/polyester fibres with a washable coated side.

The classification is valid for the following end use conditions :

Glued decorative wall covering for walls or ceilings, glued with non-woven wallpaper adhesive with a deposition of 250 to 300 g/m², on A2 cardboard plasterboard with a density greater than 525 kg/m3 or on any other substrate of end use classified A1 or A2